NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
New - R7000 Firmware Version 1.0.11.136 Released
Bug Fixes: 07/29/2022
Fixes the issue where DHCP reservation can only support 62 addresses.
NOTE: IF DNS issues are seen with this version of FW, please enable IPv6 protocols on the router. ...
What is the Mfr and model# of the Internet Service Providers modem/ONT the NG router is connected too?
What was the LED indication on the top of the router when this happened?
What CAT# lan cable are you using between the modem and router?
What devices do you have all connected?
Has a power off for 1 minute then back ON with the ISP modem and router been performed since last update?
Be sure to restart your network in this sequence:
Turn off and unplug modem.
Turn off router and computers.
Plug in and turn on modem. Wait 2 minutes for it to connect.
Turn on the router and wait 2 minutes for it to connect.
Turn on computers and rest of network.
Has a factory reset and setup from scratch been performed since last FW update?
I didn't see this with mine:
i use r7000 as 5GHz AP.
What is the Mfr and model# of the host router that the NG router is connected too?
What was the LED indication on the top of the router when this happened?
What CAT# lan cable are you using between the modem and router?
What devices do you have all connected?
I use mine in in wireless bridge mode currently. Been working fine for about a week now.