NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
New - R8000 Firmware Version 1.0.4.84 Released
Security Fixes: 3/30/22
Fixes security vulnerabilities. (Don't know if this resolves the DNS issues seen on v.76 version.)
For more information about security vulnerabilities, visit https://www.n...
firmware: V1.0.4.84_10.1.84
Model: NighthawkNighthawk X6 R8000
Device reset to factory settings.
getting this page cannot be displayed on initial page load on multiple devices but then the page loads
also huge speed drops from 250mb/s to around 50mb/s
not expecting a fix but just highlighting so netgear can see the issue and try to patch the firmware
Try enabling IPv6.
Try a factory reset and setup from scratch. Be sure to not enable Traffic Meter as well.
Trevsweb wrote:
firmware: V1.0.4.84_10.1.84
Model: NighthawkNighthawk X6 R8000
Device reset to factory settings.
getting this page cannot be displayed on initial page load on multiple devices but then the page loads
also huge speed drops from 250mb/s to around 50mb/s
not expecting a fix but just highlighting so netgear can see the issue and try to patch the firmware
sorry mentioned in my previous post the router was reset to factory settings..
traffic monitor is off. still same issue
What is the Mfr and model# of the Internet Service Providers modem/ONT the NG router is connected too?
Try enabling IPv6.
Trevsweb wrote:
sorry mentioned in my previous post the router was reset to factory settings..
traffic monitor is off. still same issue
Virgin Media: Super Hun 2ac VMDG49 which it looks like its a Netgear modem router
in full modem mode 1.03
I did another wipe of my NighthawkNighthawk X6 R8000
turned on ip6 on 6to4 as before
made sure traffic monitoring was off
Firmware Version
V1.0.4.84_10.1.84