NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.

Forum Discussion

Cecemel's avatar
Cecemel
Aspirant
Oct 22, 2015
Solved

Nighthawk R7000 as access point and USB3

I just bought this amazing router and was configuring it. Because I have a router from my service provider which is hard to switch off I'll use my netgear as access point and disabled the wireless fr...
Troubleshooting
  • JamesGL's avatar
    JamesGL
    Oct 23, 2015

    Hi Cecemel,

     

    Welcome to Community!

     

    I did try the configuration that you have and I was able to access both USBs connected on USB 2.0 and 3.0. The router was set as router and AP mode also. Have you performed factory reset or reload the firmware?

     

    Regards,

     

    JamesGL

    Community Team

JamesGL's avatar
JamesGL
NETGEAR Employee Retired
Oct 23, 2015

Hi Cecemel,

 

Welcome to Community!

 

I did try the configuration that you have and I was able to access both USBs connected on USB 2.0 and 3.0. The router was set as router and AP mode also. Have you performed factory reset or reload the firmware?

 

Regards,

 

JamesGL

Community Team