NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
R700
Il router si resetta e non ci si collega con la wifi
The actual firmware is 11.023
I use channels 5 and 2,4 in auto mode
I have not other connection near to me.
I traied to reset the appliance but now only the first led is on and all the other are off.
What is the Mfr and model# of the Internet Service Providers modem/ONT the NG router is connected too?
My internet server provide is Vodafone. I have disconnected the R7000 from router, but the problem it's the same
If your having same problems on the ISP wifi router, then you'll need to contact the ISP for help and information regarding there services.
This would be a double NAT condition which isn't recommended. https://kb.netgear.com/30186/What-is-Double-NAT
https://kb.netgear.com/30187/How-to-fix-issues-with-Double-NAT
Couple of options,
1. Configure the modem for transparent bridge or modem only mode. Then use the NG router in router mode. You'll need to contact the ISP for help and information in regards to the modem being bridged correctly.
2. If you can't bridge the modem, disable ALL wifi radios on the modem, configure the modems DMZ/ExposedHost or IP Pass-Through for the IP address the NG router gets from the modem. https://kb.netgear.com/25891/DMZ-on-NETGEAR-routers
https://kb.netgear.com/24086/How-do-I-set-up-a-default-DMZ-server-on-my-Nighthawk-router
3. Or disable all wifi radios on the modem and connect the NG router to the modem, LAN to LAN configure AP mode on the NG router.
https://kb.netgear.com/24104/How-do-I-change-my-Nighthawk-router-to-AP-mode-after-I-ve-already-run-setup