NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.

Forum Discussion

fstarne's avatar
fstarne
Aspirant
May 24, 2016
Solved

R7000 firmware version 1.0.5.64_1.1.88 released today

New Firmware Version 1.0.5.64_1.1.88 Release Notes  1.   [New Feature] Supports Smart Connect.  2.   [New Feature] Supports the Kwilt app, which can be used to view photos stored on the...
Firmware
  • ElaineM's avatar
    ElaineM
    May 24, 2016

    DwayneW Yes, it should fix it.

tomdz's avatar
tomdz
Aspirant
May 28, 2016

I've noticed that GUI Language Versions reads V1.0.6.28_2.1.38.2 after upgrading to this firmware, is this expected? Firmware Version gives the correct number.

  • IrvSp's avatar
    IrvSp
    Master
    May 28, 2016
    tomdz wrote:

    I've noticed that GUI Language Versions reads V1.0.6.28_2.1.38.2 after upgrading to this firmware, is this expected? Firmware Version gives the correct number.

    Not sure what you are looking at? I see this:

     

    Capture.JPG

     

    Did you RESET the router after install the firmware?

    • smartloom's avatar
      smartloom
      Guide
      May 28, 2016

      Does this firmware have time sync fix? I am running V1.0.5.49_20151208_timesync firmware.  Want to make sure before upgrading.

    • tomdz's avatar
      tomdz
      Aspirant
      May 29, 2016
      IrvSp wrote:
      tomdz wrote:

      I've noticed that GUI Language Versions reads V1.0.6.28_2.1.38.2 after upgrading to this firmware, is this expected? Firmware Version gives the correct number.

      Not sure what you are looking at? I see this:

       

      Router information in Advanced Home at routerlogin.net.

      Did you RESET the router after install the firmware?

       

      Yes.
      • IrvSp's avatar
        IrvSp
        Master
        May 29, 2016

        When you upgraded, how did you setup the settings? Manually or load a settings backup file?

         

        In any event it is possible the firmware load had a problem. I'd ERASE (Advanced, Administration, Backup Settings) the firmware settings and do the reset to default that way and THEN re-load the firmware (d/l it again to be safe) and install it. Then re-enter all your settings. I guess you could see if the version are correct before even re-entering the settings.