NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Solved
R7000P firmware 1.3.1.44 breaks Access Control and Attached Devices
Since upgrading my R7000P to firmware 1.3.1.44, I can no longer see attached devices, and have no way to manage them via Access Control. Before the upgrade to 1.3.1.44, I had Access Control enabled a...
BUT, after a couple more reboots things were not visible again. So it looks like reverting to 1.3.1.26 is the solution until the next firmware after 1.3.1.44.
UPDATE:
I am still on 1.3.1.44 and never reverted. Today I painstakingly did screenshots of my config, then reset the router to factory settings. After putting my settings back in, the Access Control and Attached Devices now works. In addition, both screens actually seem to reflect the custom names that I give devices on either screen.
BUT, after a couple more reboots things were not visible again. So it looks like reverting to 1.3.1.26 is the solution until the next firmware after 1.3.1.44.
Can I get some more info on this issue
1. When the device disappeared on Attached Devices page, were these devices online?
2. Are there devices wired or wireless?DarrenM
Every device disappeared including wired and wireless.
Same here. No devices show and I have both types
Forgot to answer your 1st question they were all online and functional, just not showing up as attached. I checked them.
I had the same experience. Both wired and wireless devices were all able to connect, just not visible on Attached Devices page. And they were also shown as offline on the Access Control page. Rebooting router and devices did not change anything.
Is Netgear working on a fix? If so when is it going to released?
I have the exact same issue with this model and the same firmware upgrade seems to have caused the issue for me as well. Going to down-grade since this firmware is obviously something they pushed in a hurry to get the AppArmor feature out.
