NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
R7800 defaults after power outage
Had an issue a few months back (kudos to plemans and michaelkenward for their assistance!!!) where CM1000 and R7800 needed reboot daily due to poor cable wiring. Got that corrected with new ISP run f...
something might have gotten corrupt in the firmware.
I'd try reinstalling the firmware, then do a factory reset and clean install (in case its something in the settings/backup settings corrupt)
Thanks, I'll give that a try this weekend. Thanks again for the help with the connectivity issue, signal was stable after ISP replaced the cable from the street but was still too hot, adding a 12db pad seems to have solved the problem.