NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
optimistatheart
Oct 06, 2025Aspirant
R8000 380Mbs max download unless manually set Internet Bandwidth, but reverts to slow after reboot
Further to Nighthawk X6 R8000 not getting gigabit speeds | NETGEAR Communities - "https://community.netgear.com/discussions/home-wifi-routers-nighthawk/nighthawk-x6-r8000-not-getting-gigabit-speeds/1859023" . Since moving to fiber to the premises, I have 500/50 internet connection, but I can't get these speeds unless I manually:
1. enable QOS
2. disable QOS
3. "I want to define my Internet Bandwidth": <Set to your ISP's connection Download and Upload settings that you are paying for>
After my router is rebooted though it seems to revert back to slow speeds.
Netgear can you fix this for us please?
1 Reply
- FURRYe38Guru - Experienced User
What Firmware version is currently loaded?
What is the Mfr and model# of the Internet Service Providers modem/ONT the NG router is connected too?
Be sure your using a good quality LAN cable between the modem and router. CAT6 is recommended.Has a factory reset and setup from scratch been performed since last FW update?
Try disabling the following and see:
Armor, Smart Parental Controls or Circle, IPv6, Traffic Meter. I found that if Armor, Circle or Traffic Meter had been enabled at any point in any version of FW. A factory reset is needed and setup from scratch and don't enabled these 3.