NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Bernbaum
Feb 17, 2017Aspirant
Unable to get Nighthawk R7000 Router working with my new modem
My last modem stopped working and my service provider replaced it with a Toto Link 300mBPS Wireless N ADSL Modem Router Model No. ND300 (modem and wireless router). I am not able to get my Nighthawk...
- Feb 28, 2017
Just wanted to say a big thanks to all of your help with this. I decided to contact Netgear support on this and it now appears to be working fine. When I upgraded the firmware re: latest security patch, I didn't reset the router and some residual information in my Netgear router was causing a conflict with my modem/router. Seems to have cleared up now.
May I say it's a great community and awesome to know how quickly you respond to help out a newbie.
It's greatly appreciated.
thanks
Bernbaum
IrvSp
Feb 27, 2017Master
Might not be a problem? You using the Google DNS's? If so, might just be a delay and that shows up.
iPad's and I assume iPhones capture the screen to the Camera roll by holding down the 'off' button and the Home button at the same time. The screen flashes and the output is then in the camera roll.
If you enter 10.0.0.1 in the browser URL you'll get to the router home page as well.
"Normally could access my router using http://routerlogin.net but when I do it just defaults to Genie and password recovery"
It must be going to the wrong place or when you do cancel, that is normal for the R7000 to go into P/W recovery mode.
StephenB
Feb 28, 2017Guru - Experienced User
The R7000's internet port is connected to one of the modem/gateway's LAN port? And has a 192.168.1.x address?
Can you confirm that the R7000's LAN address is set to 10.0.0.1?
- BernbaumFeb 28, 2017Aspirant
Just wanted to say a big thanks to all of your help with this. I decided to contact Netgear support on this and it now appears to be working fine. When I upgraded the firmware re: latest security patch, I didn't reset the router and some residual information in my Netgear router was causing a conflict with my modem/router. Seems to have cleared up now.
May I say it's a great community and awesome to know how quickly you respond to help out a newbie.
It's greatly appreciated.
thanks
Bernbaum