I did factory reset the system and pressed factory reset on the satellites.

Actually the link rate shows 866 mbps on 5G, I'll take back my statement, the MacBook that I used apparently got connected to the main router, instead of nearby satellite. Hence, it was on 2.4G, and it was slow. Toggling WiFi forced it to switch and now it's fast again.

So, I'll take it back :)

I'll stay on v3.2.10 for now. Will update in a week or so.

Thank you FURRYe38 for great guidance :heart:

FURRYe38 wrote:
Ya I think so. I remember someone mentioned upgrading to v1 after they had done the telnet config and it over wrote it. Unless you have a upstream router for firewall device in front, you'll have to use v10. If you can get another router in front of the RBR, then you could use v1 and block it.

Did you factory reset the system after downgrading and setting up from scratch?
How bad is the 5Ghz speed?
How are the 5Ghz channels configured?

Be sure you have CTS set for 2347 and WMM is enabled.
SergeL wrote:
Do you think 3.2.18.1 will override the settings that I made through Telnet?
FURRYe38 wrote:
If you don't have a way to block externally with a router or firewall device infront of the RBR, then you have to use the older FW version mentioned.
SergeL wrote:
Does anyone tried to update to the latest v3 after rollback?

Forum Discussion

Richiesta larghezza di banda