Powerline PLW1000 WiFi Network crash when two specific devices are connected

hello,

I did some extensive testing this evening and the issue is definitely on the WiFi access point device that starts crashing/rebooting again and again from the moment I connect two security cameras.  One WiFi camera works with PC, Phone etc connected to the WiFi, no matter which camera I use - two WiFi cameras of the same model/vendor with distinct names/MAC/IP etc... induce the WiFi device of the powerline to crash and reboot continuously one are both connected.

I say is the WiFi device because the other device of the powerline can be disconnected from the wall socket - Pick A Plug led OFF on the WiFi one - then an ethernet cable can be connected to the WiFI device which acts as an access point for the wireless devices.  Again any WiFi camera works perfectly, and once I connect both cameras the WiFi device of the powerline never ends crashing and rebooting.

Once the crash happens first the Pick A Plug led turns OFF, then after a few seconds is the WiFi led to turn OFF... in about a minute the device reboots and the process restarts.     by using the WiFi device as an access point the Pick A Plug led is already OFF,  after a while the WiFi led turns off and the device restarts, same duration.

thanks a lot

Felice