NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Solved
RS700S not delivering 1.5Gbps
I recently upgraded my modem and router so I could add more devices and get higher speeds. I purchased the Netgear Nighthawk CM2000 cable modem and the Nighthawk RS700S Wifi 7 router. According to th...
Hi BobbyP,
I checked the link speeds in the Device Manager of the Nighthawk app as you suggested and here's the result for my devices :
- iPad Pro: 2215 Mbps (40% reduction is 1,330 Mbps) at 6GHz. ST= 1,017 Mbps.
- iPad Pro: 1876 Mbps (40% reduction is 1,125 Mbps) at 5GHz. ST= 804 Mbps.
- iPhone 14: 1055 Mbps (40% reduction is 633 Mbps) at 5GHz. ST= 575 Mbps.
- Macbook: 1172 Mbps (40% reduction is 703 Mbps) at 5GHz. ST=785 Mbps.
The actual speed from the Speedtest app (ST) is next to each one.
The figures improve as I get closer to the router. I did try a 2.5 Gbps USB-C adapter with my Macbook and iPad (iMac too). For some reason I can't understand, it capped out at 940 Mbps on all, even the iPad which can get almost 1,100 Mbps wirelessly. Any thoughts on why the ethernet speeds are capped?
Thanks,
Stan
What brand and model ethernet adapter are you using?
What speeds does it support.
Tried different ethernet supporting PCs to compare speed results?
The problem was me. I was using the wrong port from the router. Once I connected the ethernet cable and 2.5GB adapter to the 10GB LAN port on the RS700 (instead of one of the four gigabit ports), I was able to receive 1,650 Mbps from all my devices via ethernet.
Now I just have to try and figure out my wireless speeds. My iPad Pro is the only 6E capable device I have (aside from Fire TV cube) and can only receive at a little over 1,000 Mbps when connected to the 6 GHz channel when I'm standing next to the router. The router is getting about 1,700 Mbps incoming, so i't not even 60% throughput. With my old RAX200 router, I got 75%-80% throughput, but incoming was only about 1,000 Mbps.
So, is it the RS700 router (setting, capabilities) or the iPad? That's where I am now.
How is the RS configured on it's basic and Advanced Wireless settings?
Channel configurations currently used?
Is Smart Connect enabled or disabled?
Is MIMO enabled under Advanced Wireless Settings?
I'm using 2.4 GHz, 5 GHz and 6 GHz channels. Guest is disabled. Smart connect is also disabled. MU-MIMO and OFDMA are both enabled.
I tried to disable OFDMA and just keep MU-MIMO but it's not possible. It seems Netgear only gives me the possibility to disable both MU-MIMO and OFDMA -or- disable just MU-MIMO but keep OFDMA. Disabling OFDMA and keeping MU-MIMO is not possible.
I attached a PDF of my basic and advanced wireless settings. Any suggestions on my settings?