Readynas 51600

---

scravatt wrote:

how to i setup for FTPS or SFTP?

---

FTPS is a bit easier - you go into the FTP settings in services, and check "Enable Force FTPS"  That ensures that unencrypted FTP will be rejected. Set the Authentication Mode to "User".

On the client side, you configure the connection to use "explicit TLS", and use a local NAS user account and password.

Personally I recommend using non-standard ports (for instance, 54321 for the control port, and 54322-54326 for passive ports).  The number of passive ports depends on the number of simultaneous users accessing the NAS.  I find that 4 ports per user is a good number.  This port range (54321-54326 in this example) needs to be forwarded to the NAS in your router.

You will also want to run DDNS so you can use a name to reach the NAS instead of using an IP address.  Most routers include DDNS support.  NoIP.com is one provider that still has a free DDNS service.

One complication with FTPS is the "Masquerade Address". This can get in the way if you want to use FTPS both on your lopal network and remotely.  If you only use it remotely, then you can set the masquerade address to your DDNS name.

Some clients - notably FileZilla - don't require masquerading.  So you can use one of those clients, and set the Masquerade Address to disabled. That would allow both local and remote access with that client.  FileZilla is available for iOS, but I don't know what alternatives would work w/o masquerading with Android.

Hello scravatt 

Use FTP and FTPS
You can use FTP and FTPS to access any shares that are enabled for the FTP and FTPS
file-sharing protocols.
For better security, use an FTPS client to connect to your ReadyNAS using the FTP
file-sharing protocol. With FTPS, your password and data are encrypted.

If you are using FTPS, you must use explicit mode (also known as FTPES or AUTH TLS)
in your FTP client.
To access a share using FTP:
1. Ensure that the FTP file-sharing protocol is enabled on your ReadyNAS system.
2. Launch an FTP client or a terminal program.
3. Log in to your ReadyNAS system, as follows:
• If you required user FTP access when you enabled the FTP-file sharing protocol,
log in using user or administrator credentials for your ReadyNAS system. If you
log in as a user, your access is limited by the settings configured by the ReadyNAS
system administrator.
• If you allowed anonymous access when you enabled the FTP-file sharing protocol,
log in as anonymous and use your email address for the password.

Have a lovely day,
Nivedita Pa
Netgear Team