NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.

Forum Discussion

bla_1's avatar
bla_1
Aspirant
Aug 06, 2020
Solved

ReadyNAS Pro 6 CPU-fan Calibration button

INFORMATION: Netgear ReadyNAS Pro 6 Firmware: 4.2.31 X-Raid 2   Fan SYS     936 rtm Fan CPU    2156 rtm   Temp SYS    45°         Normal 0-65°C     Recalibration  OK Temp CPU   25.5°C    Nor...
  • StephenB's avatar
    StephenB
    Aug 06, 2020
    Sandshark wrote:

    It's been a long time since I ran 4.2.x on a Pro6, but I don't remember two calibrate buttons. 

    There's only one (on the sys fan).  My CPU fan also always runs a bit over 2000 rpm.

Sandshark's avatar
Sandshark
Sensei - Experienced User
Aug 06, 2020

It's been a long time since I ran 4.2.x on a Pro6, but I don't remember two calibrate buttons.  But one thing that may make a difference is whether your Pro uses a 4-pin fan connected next to the CPU or a three-pin one connected to the daughterboard.  Or did you, perhaps, plug it into the wrong connector for your fan type?

bla_1's avatar
bla_1
Aspirant
Aug 06, 2020

Thanks for your answer.

I use a 4-pin connected to the mainboard. I plugged it back into the same plug as it was before the cleaning and at the time, it was working fine (at a lower speed).

 

NETGEAR Academy

Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology! 

Join Us!

ProSupport for Business

Comprehensive support plans for maximum network uptime and business peace of mind.

 

Learn More