NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Transmission failed to start - does not work!
Hi guys, Transmission DOES start, until i change the password. I changed the password from "password1" to essentially "password23" in the following:- /Transmission/transtart.sh /Transmission/t...
Hello everyone! I'm new to this forum but I've been trying to get transmission work for a couple of days and finally I made it!! :D
So I'm going to specify a pseudo guide for what I've done since I see this is sort of tricky and many people are asking for this.
Enviorenmt:
NAS: Ultra 2
RAIDiator 4.2.22
Transmission v2.77.01
OS: Windows 8
As a default install I would get the failed to start message. I did NOT update any lib or mess up with Debian files.
Steps:
1) I enable the SSH root
2) installed NotePad++ and Bitvise Client (has terminal, SSH, and SFTP so to access config files) on my PC
3) Took the json file and set it up with the help of this: http://www.readynas.com/contributed/super-poussin/Transmission-Parameters.htm
Everything that I didn't find on the site I deleted it from the json (don't know if matters but It's what I did)
4) WATCH OUT: DEFAULT gui port in JSON is 9091 whereas the other files is in 8181 CHOOSE YOURS. I stick with 8181 so to change only the JSON
5) update username:password in all the .SH
6) start the service in frontview, IT WOULD SAY AGAIN IT FAILED but I CAN SEE the GUI so i guess it's OK (haven't added a torrent yet :P)
Notes: every File edition was made with Notepad++ and file Up/down load was made with bitvise client. If do a normal Windows copy paste Windows WILL SCREW YOUR FILES! Also check after uploading files that they end up with the same execution rigths.
Good Luck!
So I'm going to specify a pseudo guide for what I've done since I see this is sort of tricky and many people are asking for this.
Enviorenmt:
NAS: Ultra 2
RAIDiator 4.2.22
Transmission v2.77.01
OS: Windows 8
As a default install I would get the failed to start message. I did NOT update any lib or mess up with Debian files.
Steps:
1) I enable the SSH root
2) installed NotePad++ and Bitvise Client (has terminal, SSH, and SFTP so to access config files) on my PC
3) Took the json file and set it up with the help of this: http://www.readynas.com/contributed/super-poussin/Transmission-Parameters.htm
Everything that I didn't find on the site I deleted it from the json (don't know if matters but It's what I did)
4) WATCH OUT: DEFAULT gui port in JSON is 9091 whereas the other files is in 8181 CHOOSE YOURS. I stick with 8181 so to change only the JSON
5) update username:password in all the .SH
6) start the service in frontview, IT WOULD SAY AGAIN IT FAILED but I CAN SEE the GUI so i guess it's OK (haven't added a torrent yet :P)
Notes: every File edition was made with Notepad++ and file Up/down load was made with bitvise client. If do a normal Windows copy paste Windows WILL SCREW YOUR FILES! Also check after uploading files that they end up with the same execution rigths.
Good Luck!
NETGEAR Academy
Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology!
Join Us!
