NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Solved
I have a readynas10400 that doesnt want to boot anymore
Hello
My RN10400 doesnt want to boot, it boots with the USB, goes out but doesnt buut without the usb
I was wondering if i take all HD and put them into a new RN314, will i recover my files?
Hi Cenoke,
Welcome to the Community!
Yes, if there are no issues on the volume on your RN104, the RN314 should boot normally when you insert the disks from the RN104 to the RN314 (disks should be on the same order) since both are OS6 devices. You may check this article for reference as well.
You can also install first a scratch disk (not from the array) to the RN314 and update its firmware, then remove the scratch disk, power down the system and insert the disks from the RN104 (disks should be on the same order).
Regards,
2 Replies
Replies have been turned off for this discussion
Hi Cenoke,
Welcome to the Community!
Yes, if there are no issues on the volume on your RN104, the RN314 should boot normally when you insert the disks from the RN104 to the RN314 (disks should be on the same order) since both are OS6 devices. You may check this article for reference as well.
You can also install first a scratch disk (not from the array) to the RN314 and update its firmware, then remove the scratch disk, power down the system and insert the disks from the RN104 (disks should be on the same order).
Regards,
Thank you so much for the reply!!
Greetz
C
NETGEAR Academy
Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology!
Join Us!
