NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Readynas 104 out of memory 390, won't boot anymore in normal mode
After facing same/similar problem after upgrading to 6.4.1, see https://community.netgear.com/t5/Using-your-ReadyNAS/Readynas-104-won-t-boot-Error-354-out-of-memory-After-upgrade-to/m-p/1033804#M1018...
Is the fan speed reported correctly in the UI?
Can you try 6.5.0 Beta 2?
mdgm wrote:Is the fan speed reported correctly in the UI?
Fan speed is reported and same as in logs. If its correct is hard to judge: 803 RPM (T = 61 C). Seems quite low RPM. Before it was usually around 1300 RPM (from logs), so 70% faster. But dont know if its under reporting or fan is really running that slow. It also doenst make a lot of noise.
Can you try 6.5.0 Beta 2?
Are there any fixes which might influence the problem? Cause a bit reluctant, now that it is still accessible in RO, dont want to loose that too. Am first preparing for another extra backup for safety before doing anything else. And just an upgrade or also factory reset again?
Is the device running hotter than normal?
- From memory, the number does seem higher now, but hard to tell as I was not really tracking it. HD temps are quite a bit lower: +- 40 vs 60 C for CPU Is the temp also somewhere in the logs dumped via RaidAr, so I can check? I found the HD temps in the logs, but didnt immediately find CPU temp.
NETGEAR Academy
Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology!
Join Us!
