NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Readynas 104 out of memory 390, won't boot anymore in normal mode
After facing same/similar problem after upgrading to 6.4.1, see https://community.netgear.com/t5/Using-your-ReadyNAS/Readynas-104-won-t-boot-Error-354-out-of-memory-After-upgrade-to/m-p/1033804#M1018...
Any idea about the normal T and RPM range?
Had been running in RO mode for the whole time.
Rebooted once again in normal mode and now there is different behavior:
NAS boots and becomes visible in Raidar.
Tried downloading logs, but that now failed after a while.
When trying again it said not a valid password.
After a while NAS dissapears from Raidar.
So far similar to before, but could usually still download some logs.
But now, there is nothing on the display, so no OOM message.
Device does seem to keep responding to ping requests, but for the rest nothing. :(
Another update.
Waited for final 6.5.0 release and did the upgrade in RO mode (without factory reset first, so in 6.4 prob situation).
After firmware update, reboot, system hangs booting 93%.
Waited a long time and then shutdown (pulled power).
Rebooted in RO mode, that still seems ok, pfhew.
In RO, rebooted via RAIDar, in normal mode again.
Shows up in RAIDar Sytem starting up..., NAS OSD progresses till 99%, then dissapears in RAIDar and then OSD shows out of memory 330 after a while.
So another version, another OOM #, but still same problem.
In this case RAIDar doesnt reach/show the buttons to Download logs
Tried it a few times, and behavior is not fully consistent.
Sometimes it hangs a bit earlier sometimes a bit later, but always around 90%.
Sometimes even seems to pass the booting, RAIDar then shows the buttons, but log download fails and also login to Admin page fails and then after a while also dissapears from RAIDar, but no OOM 330 message in this case, but NAS not responding regardless and hard poweroff needed.
This last case only happened a few times after a hot boot, from RO mode, not yet from cold boot.
In RO mode still able to get logs.
So guess its back to factory reset plan and hope it works and keeps working for 6.5.0.
NETGEAR Academy
Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology!
Join Us!
