NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
ReadyNas NV+ to Mac via Airport Express via Arris
Hi, Time Warner cable recently sent me a new cable, modem, router. It's an Arris DG1670. It created a number of conflicts on my system as I had 3 Airport Express units configured to extend my wi-fi th...
I think you probably had set up a static IP address on the ReadyNAS (and it was 10.0.1.100). Do you recall doing that?
You need to get it back into the same IP address range that your new router is using.
There are two ways to do that. One is to do an OS reinstall from the front panel. The procedure is on pages 23-24 here:http://www.downloads.netgear.com/files/GDC/RND2110/Duov1_NV+v1_HW_en_06Dec11.pdf
Afterwards, the admin password will be set to factory default ("netgear1"), and the IP address will be set back to "automatic".
The second way is to set your PC IP address temporarily to 10.0.1.101 (subnet mask of 255.255.255.0, gateway of 10.0.1.1). Then directly connect the PC ethernet to the NAS.
Then access https://10.0.1.100/admin and reset the IP configuration to automatic.
After you regain access, you should read through the router manual, and see if it supports a way to pre-assign the automatic address for the NAS. Most routers do, and it is a much better way to assign addresses.
You need to get it back into the same IP address range that your new router is using.
There are two ways to do that. One is to do an OS reinstall from the front panel. The procedure is on pages 23-24 here:http://www.downloads.netgear.com/files/GDC/RND2110/Duov1_NV+v1_HW_en_06Dec11.pdf
Afterwards, the admin password will be set to factory default ("netgear1"), and the IP address will be set back to "automatic".
The second way is to set your PC IP address temporarily to 10.0.1.101 (subnet mask of 255.255.255.0, gateway of 10.0.1.1). Then directly connect the PC ethernet to the NAS.
Then access https://10.0.1.100/admin and reset the IP configuration to automatic.
After you regain access, you should read through the router manual, and see if it supports a way to pre-assign the automatic address for the NAS. Most routers do, and it is a much better way to assign addresses.
NETGEAR Academy
Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology!
Join Us!
