NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Replacing NV+ with 104 after PSU failure. #25507979
Can I install the old disks in the new box without losing data
It doesn't appear possible to obtain a replacement PSU for the NV+. Is that the case?
Hi sfy,
Is your NV+ a v1 or v2? You can verify it by reading this link below:
http://www.rnasguide.com/2012/01/09/how-to-tell-whether-i-have-a-duo-v1-or-duo-v2-or-nv-v1-or-nv-v2/
If ever you have an NV+ v1, kindly access this forum link below:
Service Action to Prevent PSU Failures in ReadyNAS NV/NV+
If ever the serial number of your NV+ falls within the affected range, kindly contact Netgear Support for a possible replacement of the PSU:
http://support.netgear.com/general/contact/#tab-call
Regards,
DaneA
Netgear Community team
Also some NV+ are still under warranty. So you might check warranty status with Netgear.
It appears to be a V1
The serial number I have is not in the format in the article. It is 23J<reset of serial removed by moderator>
Yes, I looked that up and saw that you had a unit out of warranty.
Some older units had the serial number as the MAC address and a specific range of those units were shipped with a defect that could lead to premature fail of the PSU. Your unit is clearly not in the affected range, but if hardware is going to fail the PSU in a PC is a common component that can fail.Hi shaneyoul,
Support center already issued a replacement, see RMA 1553537 at RMA status
I think they will still give replacement for the PSU as long as they still have stocks available, but this is only for PSU not for chassis. Please check your supoport case again too.
Regards,
NETGEAR Academy
Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology!
Join Us!
