Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
WAC510 Firmware Update Failed "Device failed to connect back"
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2021-01-09
05:21 AM
2021-01-09
05:21 AM
5 of my 6 WAC510 AP's upgraded from 9.1.0.13 to 9.2.1.6 without issue. The 6th is offline with the above message. I tried powering off and back on wthout, but that didn't cure it. Any ideas?
Solved! Go to Solution.
Model: WAC510 Insight Managed Access Point
Message 1 of 2
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2021-01-10
08:32 AM
2021-01-10
08:32 AM
Found out from the NETGEAR Support Team that your WAC510 will be replaced.
Regards,
DaneA
NETGEAR Community Team
Message 2 of 2
All Replies
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2021-01-10
08:32 AM