- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
WAC510 low coverage since last firmware 1.2.5.11
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi All,
Since I updated the WAC510 with the last firmware (1.2.5.11), I noticed a big drop of the wifi coverage. Any advise before to try to return to the previous firmware to test ?
Regarding my tests, I was able to cover all my house, since the update, only 2 rooms. I also did external test, but after 25 meters, the wifi is low, and all attempts to connect fail. I tried with all my 5 devices (Apple only, I guess only 5ghz), same results.
I didn't change anything in the configuration between both firmware.
Thank you for your support.
Stef.
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Stephanfo,
Welcome to the community! 🙂
Did you perform a factory reset on the WAC510 after upgrading the firmware? If not yet, I suggest you to perform a factory reset on the WAC510 then reconfigure it from scratch in order to start clean using the latest firmware version.
Hope it helps.
Regards,
DaneA
NETGEAR Community Team
All Replies
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Stephanfo,
Welcome to the community! 🙂
Did you perform a factory reset on the WAC510 after upgrading the firmware? If not yet, I suggest you to perform a factory reset on the WAC510 then reconfigure it from scratch in order to start clean using the latest firmware version.
Hope it helps.
Regards,
DaneA
NETGEAR Community Team
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Betreff: WAC510 low coverage since last firmware 1.2.5.11
Hey Stephanfo,
did you try a reset yet and has it helped?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: WAC510 low coverage since last firmware 1.2.5.11
I just want to follow-up on this. We’d greatly appreciate your feedback.
Regards,
DaneA
NETGEAR Community Team
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: WAC510 low coverage since last firmware 1.2.5.11
Hi all,
Yes, reset to defaults solved the problem. Thank all for your help.
For the information, after factory reset, the RSSI Threshold is set to -85.
Stéphane.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: WAC510 low coverage since last firmware 1.2.5.11
Thanks for your feedback. I'm glad to know that doing a factory reset has solved the problem. 🙂
Since your concern has been resolved, I encourage you to mark the appropriate reply as the “Accepted Solution” so others can be confident in benefiting from the solution. The NETGEAR Community looks forward to hearing from you and being a helpful resource in the future!
Cheers,
DaneA
NETGEAR Community Team