Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Re: WAC720 syslog - set logging level
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2017-04-21
12:50 PM
2017-04-21
12:50 PM
I setup sysloglogging on my ensemble - problem is, is that it is filling my logs with - "Ensemble matching Behavior between ..." - severity 1. I have (4) units setup in an ensemble and I get these every couple of seconds. These should not be severity 1 (Alert) - I would think that is informational.
Solved! Go to Solution.
Model: WAC720|2x2 Wireless-AC Access Points
Message 1 of 3
Labels:
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2017-04-22
09:45 AM
2017-04-22
09:45 AM
Yes those messages are informational. We have made some enhancement in the next relase ( early May )which will supress these logs.
Thanks
Raghu
Message 2 of 3
All Replies
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2017-04-22
09:45 AM
2017-04-22
09:45 AM
Yes those messages are informational. We have made some enhancement in the next relase ( early May )which will supress these logs.
Thanks
Raghu
Message 2 of 3
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2017-05-01
08:48 AM
2017-05-01
08:48 AM
Re: WAC720 syslog - set logging level
Just installed firmware 3.7.10.0 and it appears to fix that - thanks...
Message 3 of 3