Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
WAX206 login after switching to bridge mode
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2022-04-29
02:56 PM
2022-04-29
02:56 PM
WAX206 with firmware 1.0.4.0 allows bridge mode.
I set my WAX206 into bridge mode and it works. However now I want it to connect to a different WIFI network. Question is how do I login into the WAX206 again? I know the IP address and it won't go into the dashboard. Browser can find that IP address.
Solved! Go to Solution.
Message 1 of 3
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2022-04-30
08:19 AM
All Replies
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2022-04-30
08:19 AM
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2022-04-30
04:30 PM
2022-04-30
04:30 PM
Re: WAX206 login after switching to bridge mode
I did reset and start over. That works. But was still curious why I couldn't login.
Found that using https://ip_address helps.
https://community.netgear.com/t5/Idea-Exchange-For-Business/WAX206-in-Bridge-Mode-Select-AP-via-MAC-...
Message 3 of 3