- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
WAX610 set management vlan incorrectly
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I was trying to configure a bundle of WAX610's and on the IP/Lan page, I set the access VLAN correctly but specified the wrong management VLAN. I've tried setting my managed network switch to the correct management VLAN, but they aren't connecting to the web interface. My network scanner sees them over the switch, but it just won't load the interface.
These waps are already installed, and not exactly accessible. Is there any way to get to them without doing a factory reset?
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Welcome to the community! 🙂
There is no other way but to reset the WAX610 access points to factory default settings.
Regards,
DaneA
NETGEAR Community Team
All Replies
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Welcome to the community! 🙂
There is no other way but to reset the WAX610 access points to factory default settings.
Regards,
DaneA
NETGEAR Community Team