- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
WNDAP660
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I have connected external antennas to the Prosafe access point. However I am unable to locate the setting in the interface to switch from internal to external antenna. The set up instructions indicate that this should be done. Can anyone help please.
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Advanced -> Advanced Wireless Settings -> Antenna
Select one of the following radio buttons to specify the antenna:
• Internal. Enables the internal antenna. This is the default setting.
• External. Enables an optional external antenna or antennas.
Note: This setting does not apply to the 802.11a/na modes. The way I read this: 2.4 GHz only, not 5 GHz.
Reference: NETGEAR ProSAFE Premium 3 x 3 Dual-Band Wireless-N Access Point WNDAP660 Reference Manual, p.108 ff.
Moderator, please move subject (and it's duplicate post) to the Business Wireless section, thx.
All Replies
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Advanced -> Advanced Wireless Settings -> Antenna
Select one of the following radio buttons to specify the antenna:
• Internal. Enables the internal antenna. This is the default setting.
• External. Enables an optional external antenna or antennas.
Note: This setting does not apply to the 802.11a/na modes. The way I read this: 2.4 GHz only, not 5 GHz.
Reference: NETGEAR ProSAFE Premium 3 x 3 Dual-Band Wireless-N Access Point WNDAP660 Reference Manual, p.108 ff.
Moderator, please move subject (and it's duplicate post) to the Business Wireless section, thx.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: WNDAP660
Many Thanks