Orbi WiFi 7 RBE973
Reply

Can't boot Bad Data CRC

Bubenduben
Follower

Can't boot Bad Data CRC

Hello, 

i have same issue like here:

https://community.netgear.com/t5/Stora-Legacy/NAND-corrupted-can-t-get-passed-uboot/td-p/402403


__ __ _ _
| \/ | __ _ _ ____ _____| | |
| |\/| |/ _` | '__\ \ / / _ \ | |
| | | | (_| | | \ V / __/ | |
|_| |_|\__,_|_| \_/ \___|_|_|
_ _ ____ _
| | | | | __ ) ___ ___ | |_
| | | |___| _ \ / _ \ / _ \| __|
| |_| |___| |_) | (_) | (_) | |_
\___/ |____/ \___/ \___/ \__|
** MARVELL BOARD: RD-88F6281A LE

U-Boot 1.1.4 (May 30 2011 - 09:26:20) Marvell version: 3.4.15

U-Boot code: 00600000 -> 0067FFF0 BSS: -> 006CEE60

Soc: MV88F6281 Rev 3 (DDR2)
CPU running @ 1000Mhz L2 running @ 333Mhz
SysClock = 333Mhz , TClock = 200Mhz

DRAM CAS Latency = 5 tRP = 5 tRAS = 18 tRCD=6
DRAM CS[0] base 0x00000000 size 64MB
DRAM CS[1] base 0x04000000 size 64MB
DRAM Total size 128MB 16bit width
Flash: 0 kB
Addresses 8M - 0M are saved for the U-Boot usage.
Mem malloc Initialization (8M - 7M): Done
NAND:256 MB
CRC in Flash: c899e7d0, Calculated CRC: c899e7d0

CPU : Marvell Feroceon (Rev 1)

Streaming disabled
Write allocate disabled

Module 0 is RGMII
Module 1 is TDM

USB 0: host mode
PEX 0: interface detected no Link.
Net: egiga0, egiga1 [PRIME]
Hit any key to stop autoboot: 0

NAND read: device 0 offset 0x100000, size 0x300000

Reading data from 0x3ff800 -- 100% complete.
3145728 bytes read: OK
## Booting image at 00800000 ...
Image Name: Linux-2.6.22.18-Netgear
Created: 2011-05-26 15:05:01 UTC
Image Type: ARM Linux Kernel Image (uncompressed)
Data Size: 2789276 Bytes = 2.7 MB
Load Address: 00008000
Entry Point: 00008000
Verifying Checksum ... Bad Data CRC

 

Is some way to upload image via TFTP? Where can i download uImage.netgear?

Model: MS2000|Media Server|EOL
Message 1 of 2

Accepted Solutions
FURRYe38
Guru

Re: Can't boot Bad Data CRC

I would post in that forum to see if anyone can help you out. Or make contact with NG support.

 

This is a cable modem/gateway forum. 

 

Good Luck. 


@Bubenduben wrote:

Hello, 

i have same issue like here:

https://community.netgear.com/t5/Stora-Legacy/NAND-corrupted-can-t-get-passed-uboot/td-p/402403

 

View solution in original post

Message 2 of 2

All Replies
FURRYe38
Guru

Re: Can't boot Bad Data CRC

I would post in that forum to see if anyone can help you out. Or make contact with NG support.

 

This is a cable modem/gateway forum. 

 

Good Luck. 


@Bubenduben wrote:

Hello, 

i have same issue like here:

https://community.netgear.com/t5/Stora-Legacy/NAND-corrupted-can-t-get-passed-uboot/td-p/402403

 

Message 2 of 2
Top Contributors
Discussion stats
  • 1 reply
  • 1433 views
  • 0 kudos
  • 2 in conversation
Announcements

Orbi 770 Series