- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
NETGEAR C3000-100NAS single digit speeds after upgrading xfinity speed from 100 to 200 mbps
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
NETGEAR C3000-100NAS single digit speeds after upgrading xfinity speed from 100 to 200 mbps
Then sam in India said I could figure it out and do it myself by looking in the community forums. But he couldn't answer any questions about specifics!!! Seriously shameful customer service. I don't see anyone else with a similar issues here. Is this an easy fix? Does anyone know why this is happening?
I will never purchase another netgear item again with these kinds of ethics. Before you buy I hope you read what current customers are dealing with.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: NETGEAR C3000-100NAS single digit speeds after upgrading xfinity speed from 100 to 200 mbps
Please post a copy and paste of the modems connection status page.
Have the ISP check the signal and line quality UP to the modem. Be sure the ISP provisions the modem correctly.
Be sure there are no coax cable line splitters in the between the modem and ISP service box.
Be sure your using good quality RG6 coax cable up to the modem.
Be sure to power OFF the modem for 1 minute them back ON.
https://community.netgear.com/t5/Cable-Modems-Routers/General-info-and-Troubleshooting-for-Cable-Mod...
My Setup | ISP SparkLight | Internet Cable 1000↓/50↑ CAX30 Mode Mode | Wifi Router XR500 and RBK863 Router mode | Switches NG GS105/8, GS308v3, GS110MX and XS505M | Additional NG HW: C7800/CAX3/CAX80/CM1100/CM1200/CM2000, Orbi: CBK40, CBK752, RBK50, RBK853, RBK752, RBK953, SXK30 | NightHawk: MK63, R7000, R7800, R7960P, R8000, R8500, RAXE500, RAX120v2, RAX50v2, XR450/500/700/1000, EX7500/EX7700
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: NETGEAR C3000-100NAS single digit speeds after upgrading xfinity speed from 100 to 200 mbps
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: NETGEAR C3000-100NAS single digit speeds after upgrading xfinity speed from 100 to 200 mbps
The netgear tecg support said he could fix it with remote access and me paying a warranty fee, so I think its something else that needs to be done than these suggestions. Can you think if anything else?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content