MLDonkey 3.1.5

[WhoCares_]

MLDonkey 3.1.5

• Description
  

  MLDonkey was originally intended as a pure eDonkey2000 clone, running on Unix and Linux, a sector that the original client never served well. Since the release of version 2, there has also been development to access other networks, most notably the eDonkey2000 offspring Overnet, BitTorrent, Kademlia and DirectConnect.

• Current Version: MLDonkey 3.1.5 v0.1.1
  
  

• Requirements:
  ReadyNAS Platform: Sparc
  ReadyNAS Firmware: RAIDiator 4.1.8 or better
  
  

• Installation
  For generic add-on installation instructions please see Add-On Installation
  
  

• Please Note
  Due to the limited CPU and memory resources available on the ReadyNAS Sparc line the throughput of MLDonkey on the ReadyNAS may be significantly lower than what you may be used to from running MLDonkey on your client computer. That's not a problem with the software itself.
  Also, after installation please allow at least a minute for the add-on to perform it's initial startup sequence.

• Configuration:
  
  
  • After installation of the add-on, MLDonkey's web interface can be accessed by typing

    http://<ip of your NAS>:4080/

    in your browser's address field.
    As an alternative you can click on the "Open MLDonkey's web interface" button in MLDonkey's add-on pane under "Services" -> "Installed Add-Ons".
  
  
  • Please note: To ease initial setup, there's <strong>no password</strong> set and also access is allowed from any IP address. Make sure to change these settings!
    
  
  
  • To add a password for the "admin" user, just do as told on the intro screen and enter "useradd addmin <your chosen password>" into the input box in the top center of the screen. If that worked, you'll be prompted to authenticate before you can access MLDonkey's web interface again.

[WhoCares_]

Updated to version 3.1.5.