Beamforming setup on D6300

[Silverski]

Greetings

Can anyone assist with Beamforming on D6300 Firmware V1.0.0.90_1.0.90

Regards

Silverski

[VE6CGX]

What is your question? It depends what device you have(compatible device) and implicit or explicit setting required. This sort of things can be

learned by experimenting.

[Silverski]

Greetings 

I have the Netgear D6300 with the firmware listed above.

But i can not see the setting in the advanced section under WPS

Regards

Silverski

[VE6CGX]

Do you think beam forming has something to do with beam forming?

[Silverski]

Greetings

So how do I start the Beam

Regards

Silverski

[VE6CGX]

Maybe if it is rephrased like 'beam steering', would make more sense. You can steer radio wave(beam) using hardware or software(in this case firmware) Instead of me goining into detail, search on Youtube with keyword 'Netgear router and beamforming' Have fun, hope you have some -ac mode devices to get advantage of beamforming.

[Silverski]

Greetings

I was looking for pointers to check if it is working better.

The ability to adjust, or turn  on/ off etc.

Regards

Silverski

[VE6CGX]

Then you have to download and run inSSIDer(V. 4 higher) or Acrylic to read the signal strength in numerical dbm. This utility is a MUST when you use wireless.