Nighthawk D7000 - DHCP Address Reservation not Working

[GTunney]

I've just re-applied .44 over the top of .44 already installed which keeps settings and this has resolved the issue. 

Very very stange range as I tested on my laptop and that was getting 70, looks like all devices are now getting the full 70 to them. 

[michaelkenward]

Good feedback. Yet more evidence that it sometimes helps to do a factory reset after flashing the firmware.

It doesn't always work to reload the save settings, but once again you've provided useful information on when it can work.

[adrenalize]

The only thing I noted with .44 is that I had to change my OpenVPN config on my client to the new one off the router - I'd not had to do that with the last couple of updates. Other than that OK so far - might double check the WiFi given other comments.

[jpullam]

I just bought one and am trying to install, but with problems in DHCP reservation..

My firmware says 1.0.7.2_1.1.93

It also says GUI language version 1.0.7.2_2.1.38.2

Is this the bad version 38? Why do the numbers look so different?

[ratsalad]

---

@jpullam wrote:

I just bought one and am trying to install, but with problems in DHCP reservation..

My firmware says 1.0.7.2_1.1.93

It also says GUI language version 1.0.7.2_2.1.38.2

Is this the bad version 38? Why do the numbers look so different?

---

This thread is for the D7000, that firmware version is for the R7000. 

[jpullam]

Sorry I didnt appreciate the difference in model number.

In case anyone finds this, I rolled the software back to 1.5, did a factory reset and then an ipconfig /release on my desktop and it started working.