- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Re: Can't load all settings
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Can't load all settings
To be honest I can't determine if mine is D7000v1 or D7000v2, anyway..
Why doesn't the restore mode load all the conf? I mean: >Access Controls >Email >Set Password >UPnP >LED Control Settings For example it didn't load all the devices I inserted in "Access Controls"! Is there a way to recover those settings? do you know about this kind of bug during restoring?
The last firmware version is applied: 1.0.1.64_1.0.1
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Can't load all settings
@mhaxx wrote:
To be honest I can't determine if mine is D7000v1 or D7000v2, anyway..
The v1 has a red RJ45 Ethernet WAN port, the v2 does make use of the switch port (#4) for the Ethernet WAN ... when I have it right.
@mhaxx wrote:
The last firmware version is applied: 1.0.1.64_1.0.1
This reads like a D7000v1.
@mhaxx wrote:
Why doesn't the restore mode load all the conf? I mean: >Access Controls >Email >Set Password >UPnP >LED Control Settings For example it didn't load all the devices I inserted in "Access Controls"! Is there a way to recover those settings? do you know about this kind of bug during restoring?
Hard to say. Is this a config taken on a much older firmware or a backup just taken from a working config on 1.0.1.64? Don't have any D7000 at hand - that would be something for Netgear to check.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Can't load all settings
It's a very recent backup file.
Is there anyone who can check if it happens to others than me?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Can't load all settings
@mhaxx wrote:
To be honest I can't determine if mine is D7000v1 or D7000v2, anyway..
If the label says nothing on the model number it is V1.
Same discussion here:
Can't load all settings - NETGEAR Communities
albeit in the wrong section.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Can't load all settings
It was mine that discussion (someone told me to write here, the right place).
• What is the difference between WiFi 6 and WiFi 7?
• Yes! WiFi 7 is backwards compatible with other Wifi devices? Learn more