IPv6 on Netgear D7000

[rylo93]

Hello all,

I am on Internode in Australia which supports native dual-stack IPv6. I have a Netgear D7000v2. I cannot get it to natively support IPv6 for the life of me.

I have tried all of the possible options -- the only thing that works currently is a 6to4 tunnel. While my ISP suggests using the PPPOE option for other modems and my modem appears to obtain an address using this option, my devices don't pass any IPv6 test online (even though they also are obtaining IPv6 addresses from the router...). 

Does anyone have any suggestions? See the below screenshot for my current settings.

[Chris-D7000v2]

I have the same problem using latest firmware (V1.0.0.53_1.0.2)

Very disapponted. My advice, and what I'm going to do, is find another router.

Its still the case that for IPv6 it may be better to use routers supplied by the ISP.

.