- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Is there any way to stop having to re-flash firmware on R6300v1?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
That indicates firmware corruption. Did you get a fresh copy of the fw from the NG site? Are you uploading via wired, or wireless? Had same issue with my 6300 once. Grabbed a fresh copy of fw from NG site and uploaded via ethernet connected device to the 6300. Never had the issue again. Once you have successfully updated the router, reset to factory default and reconfigure.
All Replies
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
That indicates firmware corruption. Did you get a fresh copy of the fw from the NG site? Are you uploading via wired, or wireless? Had same issue with my 6300 once. Grabbed a fresh copy of fw from NG site and uploaded via ethernet connected device to the 6300. Never had the issue again. Once you have successfully updated the router, reset to factory default and reconfigure.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Is there any way to stop having to re-flash firmware on R6300v1?
ahh! that worked! Thanks netwrks! I was missing the reset to factory default step I think. Just followed your instructions, and now I can power off the router and it turns back on again with no flashing green light of death! Thanks!!!!
• What is the difference between WiFi 6 and WiFi 7?
• Yes! WiFi 7 is backwards compatible with other Wifi devices? Learn more