- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Netgear PR2000 - no Router access after Firmware upgrade
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Netgear PR2000 - no Router access after Firmware upgrade
After factory reset, a connection via LAN and Wifi is no longer possible. LAN network does not show the desired IP 192.168.168.1. WLAN does not show a default network as described in the manual. A login for the settings is not possible. The reset button shows no change.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Netgear PR2000 - no Router access after Firmware upgrade
What are all the led's on it doing? (color, solid, blinking, etc)
Do you have the switch on wired connection?
And a device connected to the LAN port (not wan)?
Are you trying to access using routerlogin.net ?
If you hard wire a pc/laptop into it, are you able to pull up a command prompt and check what ip address the pr2000 is using?
You can also try factory resetting again. Push and hold reset for up to 30 seconds while its powered on.
• What is the difference between WiFi 6 and WiFi 7?
• Yes! WiFi 7 is backwards compatible with other Wifi devices? Learn more