This topic has been closed to new posts due to inactivity. We hope you'll join the conversation by posting to an open topic or starting a new one.
2011-04-27 12:40 PM
2011-04-28 04:03 PM
2011-04-28 04:17 PM
2011-04-28 05:38 PM
jackscorrow wrote: Hi,
I have a DGN2200 router and I just upgraded it's firmware version to 184.108.40.206_7.0.36
But I can't find anymore the Port Forwarding Settings. I need to open some ports because I use eMule.
How can I open the ports I need ?
P.S. I apologise for my bad english
2011-04-28 05:39 PM
bcondor wrote: I have exactly the same problem. I can't open port for my cctv server.
2011-04-29 03:33 AM
2011-04-29 06:07 AM
2011-04-29 06:46 AM
dhester wrote: Imbound outbound rules do not allow you to specify what ports to open other than the predefined ones
2011-04-29 06:49 AM
dhester wrote: Is there a way to reset the router to factory default as I am having trouble opening ports 2300 to 2400 as I keep getting the message "specified port(s) are being used by other configurations. Please check your configurations of Remote Management, Port forwarding, Port Triggering, UPnP Port Mapping table, RIP, and Internet connection type"
I have checked all these and can't find any conflicts.
2011-05-03 07:33 AM
jmizoguchi wrote: make sure gateway is properly setup on CCTV server
2011-05-03 05:03 PM
2011-05-04 11:34 AM
2011-05-05 03:36 PM
2011-07-26 10:09 AM
2011-08-12 04:07 AM
2011-08-15 12:06 AM
2011-09-30 04:41 PM
2011-12-05 04:44 AM
2011-12-12 09:13 AM
2011-12-12 09:22 AM
2xboxhizzy wrote: i need to know how to get 2 xboxes to run off my dgn2200!
I have read tons of stuff on the net, but nothing has really given both xbox live full access without the other getting kicked!
I'm not savvy on this stuff, so please speak "network for dummies"!!