- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Basic VPN client setup
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Basic VPN client setup
I have 5 users that will access our network through a VPN Tunnel. Is it best to use a single VPN Tunnel Setup on the Router for all 5 user connections or is it better to create a VPN Tunnel Configuration for each individual user? Is it even possible to have a separate Tunnel Configuration for each user? What is the best practice setup?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Basic VPN client setup
Hi Augello,
I suggest that you create one VPN/IKE Policy using the VPN Wizard. This will be enough for the 5 VPN clients.
Kindly access the articles below as your reference guide:
ProSAFE VPN Client: Client to Box Configuration
Configure an IPv4 IPSec VPN Connection between a Gateway and a Client - read pages 8-15
Regards,
DaneA
NETGEAR Community Team
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Basic VPN client setup
I just want to follow-up on this. Let us know if you have further questions?
If ever your concern has been addressed or resolved, I encourage you to mark the appropriate reply as the “Accepted Solution” so others can be confident in benefiting from the solution. The NETGEAR Community looks forward to hearing from you and being a helpful resource in the future!
Regards,
DaneA
NETGEAR Community Team