Reply

Re: FVS318N Firewall Settings

SamirD
Prodigy

FVS318N Firewall Settings

I'm pretty sure I've done this right and the router is simply not doing its job, but I'm asking here to confirm--how does one block a single IP on the lan from the Internet using the firewall?  Also, how would one do the same thing using a static route?

 

Thank you in advance!

Message 1 of 4
SamirD
Prodigy

Re: FVS318N Firewall Settings

No one?

Message 2 of 4
DaneA
NETGEAR Moderator

Re: FVS318N Firewall Settings

@SamirD,

 

I think you can configure a LAN-WAN Inbound rule.  Set the Service to "Any" then the Action is set to "Block Always" on the IP Address you have specified.  
 

Regards,

 

DaneA

NETGEAR Community Team

Message 3 of 4
SamirD
Prodigy

Re: FVS318N Firewall Settings

Thank you!  But that only solves the problem with inbound--I don't even want this particular IP to have outbound access either--basically I want it to be LAN only.

Message 4 of 4
Discussion stats
  • 3 replies
  • 307 views
  • 0 kudos
  • 2 in conversation
Announcements