- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Re: FVX538 Firewall Bandwidth Management
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Is it possible to limit bandwidth on one (or more) specific LAN ports?
I.E., I'd like to set LAN1 to 20Mbps (in/out) and LAN2 to 80Mbps.
Thank you!
Andrea
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Andreapier,
Welcome to our community! 🙂
As per checking, FVX538 does not support rate limiting per LAN and this type of configuration is only supported by a fully managed L3 Switch.
If ever your concern has been addressed or resolved, I encourage you to mark the appropriate reply as the “Accepted Solution” so others can be confident in benefiting from the solution. The NETGEAR Community looks forward to hearing from you and being a helpful resource in the future!
Regards,
All Replies
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Andreapier,
Welcome to our community! 🙂
As per checking, FVX538 does not support rate limiting per LAN and this type of configuration is only supported by a fully managed L3 Switch.
If ever your concern has been addressed or resolved, I encourage you to mark the appropriate reply as the “Accepted Solution” so others can be confident in benefiting from the solution. The NETGEAR Community looks forward to hearing from you and being a helpful resource in the future!
Regards,
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: FVX538 Firewall Bandwidth Management
Hi JohnCarloV!
Thanks for your answer, I'll search for a small managed switch to do the job. 🙂
Best regards,
Andrea