- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Fios internet to fvs318n switch
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Fios internet to fvs318n switch
recently got verizon fios installed they use a fios-g1100 modem i need to run to my prosafe fvs318n switch for my cpu's hardwire internet but not getting a connection. Is there special access or password I need for fios to be recognized?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Fios internet to fvs318n switch
Hi @broadwayfred,
Welcome to the community! 🙂
I searched online about the Fios G1100 modem and I found out that it is a modem-router combination. I suggest you to set the Fios G1100 modem-router on full-bridge mode so that it will a modem-only device. Then, connect the Fios G1100 modem to the WAN port of the FVS318N and configure the FVS318N for internet access. Be sure to get the ISP login and password from your Internet Service Provider. Kindly access and read the article below and use it as your guide on how to configure the IPv4 internet connection on the FVS318N:
FVS318N Initial Access and Basic IPv4 Internet Configuration
Regards,
DaneA
NETGEAR Community Team
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Fios internet to fvs318n switch
I just want to follow-up on this. We’d greatly appreciate your feedback.
Regards,
DaneA
NETGEAR Community Team