Orbi WiFi 7 RBE973
Reply

Full FVS318 VPN network accessibility from NetGear ProSafe VPN Client Lite

Pineapple3
Aspirant

Full FVS318 VPN network accessibility from NetGear ProSafe VPN Client Lite

Hi everyone !

 

Two FVS318s are connected via the Internet into a single VPN.
Local addresses of one network 192.168.0.0, second 192.168.1.0
Everything works well, devices on one network are accessible from another and vice versa.

I connect via NetGear Prosafe VPN Client Lite to a device with a local network 192.168.1.0. The software client has the address 10.10.10.2
All devices of the 192.168.1.0 network are visible normally, but there is no access to devices 192.168.0.0, even FVS318 with the address 192.168.0.1 does not ping ...

Tell me where to configure what to have normal access to devices on the second network. I suppose that it is the firewall of the 192.168.0.1 router that blocks this access, but here's how to properly allow it?

We are not talking about local firewalls on computers, since I need access to a hardware IP phone on the 192.168.0.1 network

 

THANK YOU !
------------

 

Also, please tell me where can I get (or buy) license keys for NetGear Prosafe VPN Client Lite?
NetGear itself probably has a lot of these keys, but the link for buying them from the program does not work.

 

Good luck!

Model: FVS318G|ProSafe Gigabit 8 Port VPN Firewall
Message 1 of 3
DaneA
NETGEAR Employee Retired

Re: Full FVS318 VPN network accessibility from NetGear ProSafe VPN Client Lite

@Pineapple3

 

Welcome to the community! 🙂 

 

Since the site-to-site VPN is working fine between the 2 FVS318G, why not just use it to access the device on the 192.168.0.1?  

 

Be informed that the ProSAFE VPN Firewall Routers of NETGEAR is already EoL (End of Life) and this also includes the ProSAFE VPN Client software. 

 

 

Regards,

 

DaneA
NETGEAR Community Team

Message 2 of 3
Pineapple3
Aspirant

Re: Full FVS318 VPN network accessibility from NetGear ProSafe VPN Client Lite

Thanks for the answer ! 🙂

 

This is an interesting simple solution, but my task is somewhat more complicated and from the VPN software client I need to see both segments of the VPN network (192.168.1.0 and 192.168.0.0).

 

I figured it out a bit and changed the subnet mask to which I connect in the settings of the VPN software client and in the corresponding entry for the software client on the router.

Instead of 192.168.1.0 mask 255.255.255.0
i wrote 192.168.1.0 mask 255.255.254.0

 

AND MIRACLE!

 

Router 192.168.0.1 started pinging!
However, this router itself blocks further access to the addresses 192.168.0.2 - 192.168.0.254 from the software client
VPN (with the address I will remind 10.10.10.2)

 

I tried to add this address (10.10.10.2) to the Security LAN DMZ Rules section (both directions) on the router with the address 192.168.0.1

But the miracle did not happen 😞 😞

Message 3 of 3
Discussion stats
  • 2 replies
  • 692 views
  • 0 kudos
  • 2 in conversation
Announcements