Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Netgear Lan to Lan Routing how does it work?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2012-09-27
06:14 AM
2012-09-27
06:14 AM
Netgear Lan to Lan Routing how does it work?
Hi Folks,
I have a subnet 192.168.100.x which cannot change due to our provider. Within this Subnet I have an UTM5 as a Gateway. Since IP Adresses are getting short in my subnet I want to put another Router behind the first one and plug all of my thin clients into this new subnet. When configured as a NAT device the TCs perfectly see all Servers in the 192.168.100.x net, but the servers cannot connect to the TCs. How do I have to configure the two Routers, that aevery device cann connect to any other in both subnets? :confused:
Thanks in advance!
Tob
I have a subnet 192.168.100.x which cannot change due to our provider. Within this Subnet I have an UTM5 as a Gateway. Since IP Adresses are getting short in my subnet I want to put another Router behind the first one and plug all of my thin clients into this new subnet. When configured as a NAT device the TCs perfectly see all Servers in the 192.168.100.x net, but the servers cannot connect to the TCs. How do I have to configure the two Routers, that aevery device cann connect to any other in both subnets? :confused:
Thanks in advance!
Tob
Message 1 of 2
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2012-09-27
09:23 AM