- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Re: Remote IP Subnet is same as LAN IP Subnet traffic won't route
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Local Office LAN IP Subnet is 192.168.1.0
Remote Home LAN IP Subnet is 192.168.1.0
VPN Client connects but nothing routes. I beleive this is because both LANs are on the same subnet. Is there any way to configure the Remote Client Setup to allow this to work or do I have to put the Remote User's LAN on a different Subnet.
BTW: that is what I did to fix it on one client but I have many home users with Routers that default to use the 192.168.1.0 subnet.
Yes: Shame on me for leaving my office LAN on the default Subnet of 192.168.1.0.
Thank you in advance for any suggestions.
Mike
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The only solution here is to change the LAN IP Subnet to a different IP address range. It is either you change the IP address range of the Local Office LAN IP Subnet or Remote Home LAN IP Subnet
Regards,
DaneA
NETGEAR Community Team
All Replies
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The only solution here is to change the LAN IP Subnet to a different IP address range. It is either you change the IP address range of the Local Office LAN IP Subnet or Remote Home LAN IP Subnet
Regards,
DaneA
NETGEAR Community Team