- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Re: SRX5308 multiple connection issues
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
SRX5308 multiple connection issues
Hello,
I have 3 4G connections and am trying to use load balancing by aggregating the 3 to increase bandwidth on my LAN. I can setup the 3 connections individually using auto detect. As soon as I enable load balancing, the first WAN connection is shown as "UP" and the 2 others (WAN2 and WAN3) are shown as down and a "connecting" message keeps coming up. After enabling load balancing, there is no more internet traffic at all. Any ideas / clues highly appreciated.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: SRX5308 multiple connection issues
Hi bradfeney,
Let us try to isolate the problem. Kindly answer the questions below:
a. Were all of the 3 4G connections working fine with the SRX5308 before?
b. Are all of the 3 4G connections coming from the same ISP?
c. Are you using a 4G USB modem/router or a 4G modem-only device?
d. What is the current firmware version of the SRX5308?
e. Have you tried to reboot the SRX5308?
f. Have you tried to factory reset the SRX5308?
I look forward to your response. Welcome to the community!
Regards,
DaneA
NETGEAR Community Team