- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
VLAN tagging on WAN Port
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Can anyone advise whether or not it is possible to configure VLAN tagging on the WAN ports of the SRX5308 (Firmware Version: 4.3.5-3).
This is, unfortunately, a requirement of the ISP on the Austranlian NBN network.
The ISP in question (Commander) requires the following:
PPPoE over VLAN100 and mark all traffic including authentication 802.1p=0
(from their website)
The supplied POS gateway wouldn't even qualify as a domestic unit, so I'm keen to just bin it and use the existing SRX instead.
Any help, greatly appreciated.
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi HerumakiloAgain,
Welcome to our community! 🙂
Unfortunately, SRX5308 does not support VLAN on the WAN port but you can assign PPPoE connection.
Regards,
John
NETGEAR Community Team
All Replies
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi HerumakiloAgain,
Welcome to our community! 🙂
Unfortunately, SRX5308 does not support VLAN on the WAN port but you can assign PPPoE connection.
Regards,
John
NETGEAR Community Team
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content