- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Yet another complaint about "[SRX5308][Kernel][KERNEL] Port 0 receive error code 10, packet dropped"
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Yet another complaint about "[SRX5308][Kernel][KERNEL] Port 0 receive error code 10, packet dropped"
Forums have tons of complaints about "[SRX5308][Kernel][KERNEL] Port 0 receive error code 10, packet dropped" flood in the logs and no real solutions, but my case is most astonishing: I don't even have WAN ports connected to anything now!!! (Using device as a local router/DHCP server, LAN1 is also empty BTW.) Yet I receive 3 lines like this approximately every minute, at irregular intervals. Is there any way to stop this insanity?
(Firmware 4.3.5-3 if that still matters.)
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Yet another complaint about "[SRX5308][Kernel][KERNEL] Port 0 receive error code 10, packet d...
Hi @rqc,
Since nothing is connected to the WAN ports, I suggest you to perform a factory reset on the SRX5308 then reconfigure the settings from scratch. Observe if the same logs will still show up.
Regards,
DaneA
NETGEAR Community Team
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Yet another complaint about "[SRX5308][Kernel][KERNEL] Port 0 receive error code 10, packet
Actually, this device was already factory reset and configured from scratch about 2 weeks ago. I cannot experiment with it right now, but when I can I'll check when these messages first appear after factory reset and report back. Still it's funny exact underlying cause for them is not understood by anyone.