- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Dual DHCP helpers on switches
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hiya,
Our network department is using Netgear switches of some type and they have dhcp helpers for each VLAN.
I am setting up 2 DHCP(NLB\Failover) servers in the environment on Windows 2012R2, is it possible to point the DHCP helper on the switches, to both DHCP servers incase one goes down?
cheers Mike
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi mike1971wright,
Welcome to the community!
Netgear Switch support config more than one DHCP L3 Relay Server IP address.
In your scenario, if you config two DHCP helper IP address, when Switch receive client DHCP Discover packet, it will forwarding packet to both two Servers, and when Switch receive two DHCP Server response packet, it will forwarding to client, and let client to select which Server.
Hope it can helps!
Regards,
EricZ
NETGEAR employee
All Replies
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi mike1971wright,
Welcome to the community!
Netgear Switch support config more than one DHCP L3 Relay Server IP address.
In your scenario, if you config two DHCP helper IP address, when Switch receive client DHCP Discover packet, it will forwarding packet to both two Servers, and when Switch receive two DHCP Server response packet, it will forwarding to client, and let client to select which Server.
Hope it can helps!
Regards,
EricZ
NETGEAR employee