Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Re: I want to connect to M4300 with CLI.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2020-07-12
06:53 PM
2020-07-12
06:53 PM
Hi
I want to connect to M4300 with CLI.
・Speed: 9600
・data 8bit
・Parity: none
・Stop bit: 1bit
・Flow control: none
I have configured it, but nothing is displayed in the CLI.
I think the driver is fine as I can connect to Cisco equipment using the same console cable.
Please let me know if there are other causes.
Regards,
Solved! Go to Solution.
Model: GSM4328S|M4300-28G - Stackable Managed Switch with 24x1G and 4x10G including 2x10GBASE-T and 2xSFP+ Layer 3
Message 1 of 3
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2020-07-12
11:38 PM
All Replies
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2020-07-12
11:38 PM
2020-07-12
11:38 PM
Thank you for using NETGEAR M4300 seriee.
Just use 115200 bps speed
Just use 115200 bps speed
Message 2 of 3
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2020-07-13
10:50 PM
2020-07-13
10:50 PM
Re: I want to connect to M4300 with CLI.
Thank you very much. I was able to connect to CLI.
Message 3 of 3