Upgraded the FW of 1 unit to 10.0.2.35 (from 10.0.2.26) & rebooted. - all working well & POE is on (was working before upgrade)
Upgraded the 2nd unit to 10.0.2.35 (from 10.0.2.26) & rebooted - POE is not working
used CLI to turn on the POE - no help
---
POE info of bad unit
from sw105 (M4100-50G-POE+) (Config)#show poe
Firmware Version............................... Request timeout PSE Main Operational Status.................... Request timeout Power Source................................... Main AC Threshold Power................................ Request timeout Total Power Consumed........................... Request timeout Usage Threshold................................ 90 Power Management Mode.......................... Dynamic Traps.......................................... Enable
POE info of good unit
from sw016 (M4100-50G-POE+) (Config)#show poe
Firmware Version............................... 1.8.0.1 PSE Main Operational Status.................... ON Total Power (Main AC).......................... 384 W Total Power (RPS).............................. 0 W Power Source................................... Main AC Threshold Power................................ 345600 mW Total Power Consumed........................... 9500 mW Usage Threshold................................ 90 Power Management Mode.......................... Dynamic Traps.......................................... Enable
---
any suggestions on how to turn on POE?
Since it is a main production switch, It causes a major disturbance to reboot the switch.
