M4300-52G ProSAFE 4G24725T000C6 force speed 1G

[scolson]

Hi,

I have a stack of 6 M4300-52G

I try to force a port 1G in a 1G speed

when I try in cli I have the choise of 10mb 100mb and 10G

it's not a 10G port

you can see a print screen of the cli http://imgur.com/a/O0eKT

best regards,

[TCan]

My guess would be that you don't have that as a choice as it is the default speed.

If you have a piece of equipment that you believe is 1Gb but connecting at a lower speed then I would try another cable as a faulty cable will cause this issue (assuming you have checked the settings on the other equipment and it isn't faulty). Also check there is no damage to the ethernet ports.

[ElaineP]

Hi  scolson,

Under one interface, you can configure ‘speed auto 1000’ to force 1G speed. Due to M4300-52G still support 10G speed for other ports(port49,50,51,52), so under any interface, 10G speed can be seen. The switch displays all speeds for every interface.

Regards,

NETGEAR Employee